Technical data

U26140-J-Z146-3-76 1
1 Preface
This manual describes the drives for removable media and for hard disks that
you can install in your RM300 E or RM400 E system unit. The drives are
operated under the Reliant UNIX operating system. This manual is aimed at
those responsible for installing and operating the drives.
When installing storage devices, please follow all the instructions in the
sequence specified in the technical description of the product manual for your
system unit in order to avoid errors and speed up the process. Which instruc-
tions are relevant to you depends on the hardware installed in your system unit.
This manual describes how to configure, operate and maintain the drives. For
further details refer to the manual “Reliant UNIX Installation Guide“ supplied
with the software. Application programs are installed and configured under
Reliant UNIX.
If you do not wish to perform the upgrade procedure yourself, you can avail
yourself of the installation service offered by Fujitsu Siemens Computers
GmbH.
1.1 Structure of the manual
After the section entitled “Important notes”, you will find information on configu-
ration, operation, handling volumes, maintenance and accessories for the
following drives:
– Quarter-inch cartridge tape drives
– 4 mm MTC drives
– 8 mm MTC drive (7 Gbyte)
– 8 mm MTC drive (20 Gbyte)
– Autoloaders
– CD-ROM drives
– Hard disk drives
How to operate the floppy disk drive that comes already fitted in your system unit
is described in your system unit product manual.