User's Manual
Table Of Contents
- SATA Product Manual
- Seagate® Technology Support Services
- 1.1 Introduction
- 1.2 Drive specifications
- 1.2.1 Specification summary tables
- 1.2.2 Formatted capacity
- 1.2.3 Recording and interface technology
- 1.2.4 Start/stop times
- 1.2.5 Power specifications
- 2.6 Environmental limits
- 1.2.6 Acoustics
- 1.2.7 Test for Prominent Discrete Tones (PDTs)
- 1.2.8 Electromagnetic immunity
- 1.2.9 Reliability
- 1.2.10 HDD and SSD Regulatory Compliance and Safety
- 1.2.11 Corrosive environment
- 1.2.12 Reference documents
- 1.2.13 Product warranty
- 1.3 Configuring and mounting the drive
- 1.4 Serial ATA (SATA) interface
Seagate IronWolf Pro Serial ATA Product Manual, Rev. C 42
www.seagate.com Serial ATA (SATA) interface
16..23
Current SATA Settings (QWord)
63 Shall be set to one 1
62:14 Reserved 0
13 hybrid enabled 0
12 rebuild assist enabled 0
11 power disable feature enabled 0
10 device sleep enabled 0
9 automatic partial to slumber transitions enabled 0
8 software settings preservation enabled 1
7 hardware feature control is enabled 0
6 in-order data delivery enabled 0
5 device initiated power management enabled 0
4 dma setup auto-activation enabled 1
3 nonzero buffer offsets enabled 0
2:0 current negotiated serial ata signal speed (6.0, 3.0, 1.5) Gb/s
24..39 Reserved
40..41 CURRENT HARDWARE FEATURE CONTROL IDENTIFIER (Word)
42..43 SUPPORTED HARDWARE FEATURE CONTROL IDENTIFIER (Word)
44..47 Reserved
48..55
Device Sleep Timing Variables (QWord)
63 devslp timing variables supported 0
62:16 Reserved 0
15:8 devsleep exit timeout (deto) 0
7:5 Reserved 0
4:0 minimum devslp assertion time (mdat) 0
56..511 Reserved
Table 9 Identify Device Data log (Continued)