User's Manual

Seagate IronWolf Pro Serial ATA Product Manual, Rev. C 21
www.seagate.com Configuring and mounting the drive
1.3.4 Drive mounting
Users can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the
bottom-mounting holes. See Figure 3 for drive mounting dimensions. Follow these important mounting precautions
when mounting the drive:
 Allow a minimum clearance of 0.030 in (0.76mm) around the entire perimeter of the drive for cooling.
 Use only 6-32 UNC mounting screws.
 The screws should be inserted no more than 0.140 in (3.56mm) into the bottom or side mounting holes.
 Do not overtighten the mounting screws (maximum torque: 6 in-lb).
1.3.4.1 Mechanical specifications
Refer to Figure 3 for detailed mounting configuration dimensions. See Section 1.3.4, “Drive mounting.”
NOTE These dimensions conform to the Small Form Factor Standard documented in SFF-8301
and SFF-8323, found at www.snia.org/technology-communities/sff/specifications.
Figure 3. Mounting configuration dimensions
NOTE The image is for mechanical dimension reference only and may not represent the actual drive.
Weight: 1.521 lb 690 g
2X 1.625±.020
2X 3.000±.010
4.000±.010 LQ
1.432
.125±.010
3.750±.010
.814
2.000
4X 6-32 UNC 2B
3 MIN THREAD DEPTH
.14 MAX FASTENER PENETRATION
MOUNTING HOLE.
MAX TORQUE 6 IN/LBS
B
Y
.250±.010
5.787LQ MAX
146. MM
1.122±.020LQ
4.000±.010
1.638±.010
2X 6-32 UNC 2B
3 MIN THREAD DEPTH
.14 MAX FASTENER PENETRATION
MOUNTING HOLES BOTH SIDES.
MAX TORQUE 6 IN/LBS
Y
Z
1.028LQ MAX
26.11MM
.138 ±.015
2.000
C
L
OF DRIVE
C
L
OF DRIVE
C
L
OF CONN
Z
28.50 ±.51 mm
101.60 ±.25 mm