Hardware manual

NETGEAR ReadyNAS 202
34
ReadyNAS OS 6 Desktop Storage Systems
• Memory test. Performs a memory test. The memory test runs for 8hrs. The current status
and the pass or fail result is reported using the storage system LEDs, as described in the
following table:
Memory Test State Power LED Disk 1 LED Disk 2 LED Backup LED
1st hour Off Off Off Blinking
2nd hour Off Off Blinking Off
3rd hour Off Blinking Off Off
4th hour Off Blinking Blinking Blinking
5th hour On Off Off Blinking
6th hour On Off Blinking Off
7th hour On Blinking Off Off
8th hour On Blinking Blinking Blinking
Result: fail Blinking Blinking Blinking Blinking
Result: pass On On On On
• Test disk. Performs an offline full disk test. This process can take four hours or more,
depending on the size of your disks. Any problems are reported in the system logs. For
more information about viewing the system logs, see the ReadyNAS OS 6.2 Software
Manual, which is available at http://support.netgear.com/product/ReadyNAS-OS6.
 To access the boot menu:
1. Power of
f your storage system.
2. Using a straightened paper clip, press and hold the Reset button.
3. Press the Power button.
The system powers on.
4. Continue to press the Reset button until the Power button LED, USB and backup status
LED, disk 1 LED, and disk 2 LED light.
5. Press the Backup button to scroll through boot mode options.