Product manual

Bytes
Bits
7654321 0
00010101 1
1 LUN 0000 0
2–5 Logical block address
60000000 0
70000000 0
80000000 0
90000000 0
3.6.5 Write and Verify command (2E
H
)
When the drive receives the Write and Verify command, it writes the data
sent by the initiator to the media and then verifies that the data is correctly
written.
If the host adapter supports disconnection, the drive disconnects while
it is executing this command.
Bytes
Bits
7654321 0
00010111 0
1 LUN 0 0 0 BytChk 0
2–5 Logical block address
60000000 0
7–8 Transfer length
90000000 0
Byte 1
If the
byte check (BytChk) bit is 0, the drive verifies the
media after a write by checking the ECC syndromes. If the
BytChk bit is one, the drive verifies the media after a write
by performing a byte-by-byte comparison of the data stored.
Bytes 2–5
The
logical block address field specifies the logical block
where the drive begins writing and verifying the data.
Bytes 7–8
The
transfer length field specifies the number of contiguous
logical blocks to be transferred. If the transfer length is 0,
the initiator does not transfer any data and the drive does
not write or verify any data. This condition is not considered
an error.
Medalist Pro 2160N/2160WC Product Manual, Rev. A 67