Product manual

2.5 ST52160N interface connector
The ST52160N uses a standard 50-pin, nonshielded, keyed connector.
The connector consists of two rows of 25 male contacts 0.100 inches
apart. Pin 1 on the connector is shown in Figure 3 on page 19. Recom-
mended mating connectors and their part numbers are
listed below.
Part numbers for mating 3M connectors that are compatible with the
drives are listed below. These connectors do not have a center key and
are available with or without strain relief.
Without strain relief
No center key
With strain relief
No center key
Closed end
(for cable ends)
3M
3425-7000
3M
3425-7050
Open end
(for daisy chain)
3M
3425-6000
3M
3425-6050
Part numbers for mating Molex connectors compatible with the drives
are listed below. These connectors have a center key.
Closed end
(for cable ends)
Molex
39-51-2504
Open end
(for daisy chain)
Molex
39-51-2501
Below are part numbers for strain reliefs that can be used with the Molex
connectors.
Molex strain relief,
preferred version
in Europe
Molex 90170-0050
Molex strain relief,
preferred version
in Japan
Molex 15-25-1503
20 Medalist Pro 2160N/2160WC Product Manual, Rev. A