Product manual
Error code (hex)
DescriptionByte 12 Byte 13
19 02
Error in PList
19 03
Error in GList
1A 00
A parameter overrun occurred.
1C 00
The defect list could not be found.
1C 01
The primary defect list could not be found.
1C 02
GList not found
1D 00
A miscompare occurred during a verify
operation.
20 00
The drive received an invalid command
operation code.
21 00
The logical block address was not within the
acceptable range.
24 00
The drive received a CDB that contains an
invalid bit.
25 00
The drive received an invalid LUN.
26 00
The drive received an invalid field in the
Parameter List.
26 01
CDB with unsupported parameter
26 02
CDB with invalid parameter
26 03
CDB with unsupported threshold parameter
29 00
A power-on reset or a bus device reset
occurred.
2A 00
Parameter changed by another initiator
2A 01
The Mode Select parameters were changed
by another initiator.
2A 02
Log parameters changed
2F 00
Commands cleared by another initiator
31 00
Medium format corrupted
32 00 No spare defect locations available.
39 00 Saved pages not found
3F 01
The firmware/microcode was changed.
Medalist Pro 2160N/2160WC Product Manual, Rev. A 95