Specifications

RN: 4-10
RS3: Software Release Notes for P1 R4.2
P1 R4.x Changes to RS3 manuals
0I SCSI host adaptor (1984--1140--000x)
1 Install 4 SCSI terminator resistors (F/N 19) in the 4 socket locations
as shown. A m ark (DOT, BAR) at one end of the resistor network
indicates Pin1. See Figure 4.7 for details.
2 This board is now 1984--1140--0003. Change the part number label
to 1984--1140--0003.
Table 4.6. Connector Table 1
SCSI Signal (10P57159902)(Hard Disk and Tape Drive)
Connector Ref. Destination Ref. Term Ref.
P137 Card Cage J088
P138 Hard Disk J1
P134 Tape Drive -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
SCSI Signal (1984--1895--9909)(Hard Disk Only)
Connector Ref. Destination Ref. Term Ref.
P136 Card cage J088
P138 Hard Disk J1
Table 4.7. Connector Table II
SCSI (10P56909902)
Connector Destination
P982 Tape drive, main board on bottom or floppy disk drive
P980 Tab F/N 13 (Oper already installed) or floppy disk drive bracket
P978 Motherboard on CCI (J920)
P977 Motherboard (same) J933
P979 Leave hanging
P983 Disk drive
P984 Tie--wrapped back against cable, not used