Specifications

RN: 4-9
RS3: Software Release Notes for P1 R4.2
P1 R4.x Changes to RS3 manuals
Upgrade Instructions for Disk Only Consoles —0019, —0020
Description:
The upgrade kit (1984--3045--0019 or 1984--3045--0020) includes the
necessary hardware, Table 4.5, to add a hard disk to an existing
console. With one of these kits a dual tube can be split into two singles
or with two of these kits a triple tube can be split into three singles.
Minimu m firmware requirements:
BOOT ROM 68040=V10.10 (MTCC) OR V11.10 (SMS). Minimum
software requirements: P1 R3.2
CAUTION
Prior to working inside an electronics cabinet, b e su re you
are wearing a static grounding strap (1984--2718--0001).
Insure that the strap is properly grounded to the chassis.
Upgrade
Use the following instructions to upgrade the --0019 and --0020 control
consoles:
1 Power cabinet down.
2 Remove screws on the drive mounting can brackets for both the hard disk
and tape drive. Slide mounting cans out of the mounting brackets.
3 Carefully remove power and SCSI cables from the rear of both the hard
disk and tape drive. If the e xisting drives are mounted in small mounting
cans, remove the hard disk and tape drive from the mounting cans. If the
drives are in wide mounting cans, mount the second set of drives as
explained in step 4.
4 Mount the hard drive in one wide mounting can
(P/N 1984-- 2761--0001) as shown in Figure 4.6.
5 Table 4.6 and Table 4.7 show the connections for SCSI cable and SCSI
power cable.
6 Reinstall mounting cans in cabinet and tie wrap wiring as necessary.
Attempt to keep SCSI cable as far as possible from the power cables. Do
not tie wrap the SCSI cable.
7 Ensure onboard SCSI bus termination exists.
SCSI board 2 (1984--3301--0001)
JumperHD3to1—2.