Specifications

RN: 4-8
RS3: Software Release Notes for P1 R4.2
P1 R4.x Changes to RS3 manuals
Minimu m firmware requirements:
Boot ROM 68040=V10.10 (MTCC) OR V11.10 (SMS) is the minimum
software requirements: P1 R3.2
CAUTION
Prior to working inside an electronics cabinet, b e su re you
are wearing a static grounding strap (1984--2718--0001).
Insure that the strap is properly grounded to the chassis.
Upgrade
Use the following instructions to upgrade the --0017 and --0018 control
consoles:
1 Power down the cabinet.
2 Remove screws on the drive mounting can brackets for the new hard
disk location. Slide mounting cans out of the mounting brackets.
3 Carefully remove power and SCSI cables from the rear of the existing
drive. If the existing drive is mounted in a small mounting can,
remove the drive from the mounting can. If the drive is mounted in a
wide mounting can, mount the second drive as explained in Step 4.
4 Mount the tape drives in one wide mounting can (p/n
1984--2761--0001), as shown in F igure 4.5. Mount the hard disks in
the other wide mounting can as shown in Figure 4.6.
5 Table 4.6 and Table 4.7 show the connections for cables
10P57159902 (SCSI) and 10P56909902 (power) respectively. No
more than two drives can be connected to a single card cage and
one must be a hard disk. Dual and triple OI card cage installations
should be handled as follows: ( See KBA BUR1--109--981016142624
for more information.)
D Dual card cage configuration to two singles:
Each card cage will now have its own set of drives and
connection cables. the cables should be connected as shown in
Table 4.6 and Table 4.7.
D Triple card cage configuration to three singles:
Each card cage will now have its own set of drives and
connection cables. The cables should be connected as shown in
Table 4.6 and Table 4.7.