Specifications

RN: 4-6
RS3: Software Release Notes for P1 R4.2
P1 R4.x Changes to RS3 manuals
Unformed Pins Formed Pins
Side view of EPROM chips
Figure 4.4. EPROM Pin Alignment
7. Once formed, position the chip directly over the socket WITH
THE NOTCHED EDGE OF THE SOCKET LINING UP WITH THE
NOTCHED EDGE OF THE CHIP.
8. Slowly lower the chip into the socket. If the pins are not lining up
with the socket holes, reform the pins as needed. Lower the chip
onto the socket. When all of the pins are started into the socket
holes, press the chip down firmly onto the socket.
9. Repeat steps 4-6 to install the other EPROM chip.
10.Return the Assembly board to its original location.
Console Upgrades — 4.5 GB Disk
Upgrade Instructions for Consoles —0017, —0018
Upgrade Consoles
Table 4.4 shows the consoles that can be upgraded.
Table 4.4. Consoles Upgrade Kit 1984-3045
Dash Numbers
Description
--0001, --0002, --0003,
--0004, --0005, --0006,
--0007, --0008, --0010,
--0012, --0014, -- 0016
Obsolete
--0017 Tape drive, 4.5GB hard disk, cables, mounting can
--0018 Tape drive, 4.5GB hard disk, cables, W/O mounting can
--0019 4.5GB hard disk only, cables, mounting can
--0020 4.5GB hard disk, cables, W/O mounting can