Specifications

RN: 4-2
RS3: Software Release Notes for P1 R4.2
P1 R4.x Changes to RS3 manuals
Table 4.2. P1 R4.x/68040 Console Boot ROM and Graphics Card Requirements
OI Processor Board w/Graphics CardBoot ROM
10P55270010 (all revs) 1984--3204--1010 (Ver . 10.10*) 1984--2503--0001
10P55270010 (all revs) 1984--3204--1012 (Ver 10.12*)
1984--2503--0001 or
10P58900001
* The Boot ROM level X.YY is the minimum required; a higher .YY number will also work.
Table 4.3. P1 R4.x/SMS Console Boot ROM and Graphics Card Requirements
OI Processor Board
Boot ROM w/Graphics Card
10P55270011 (all revs) 1984--3204--1110 (Ver 11.10*) 1984--2503--0001
10P55270011 (all revs) 1984--3204--1112 (Ver 11.12*)
1984--2503--0001 or
10P58900001
* The Boot ROM level X.YY is the minimum required; a higher .YY number will also work.
NOTE: If the OI Processor board has a later version of the Boot ROM
than those listed here, do not replace the Boot ROMs, as all later
versions will support both boards. Each EPROM is labeled with the
version (also called the revision level) number of the software. Only
earlier versions than those listed here will have to be upgraded.
68020 OI Processor EPROM Upgrade
PURPOSE:
This procedure is intended to allow personnel with maintenance training
and responsibility for RS3 Systems to add the necessary hardwar e to
upgrade an existing 68020 OI Processor Board (P/N 1984-1540-0009)
to the latest version Boot ROM.
NOTE: T he 68020 processor board is not supported with P1.
NOTE: It is required that anti -static wrist straps are used whenever
handling the circuit boards, that the boards are transported in anti -static
bags or boxes, and that an anti -static work surface is used when
removing and installing the EPROMs.
PROCEDURE:
1. Turn the system off. Pull the board to be upgraded out of the
system.
2. Verify that the board is PWA 1984 -1540 -0009. (See Figure 4.1)