Specifications

RN: 4-1
RS3: Software Release Notes for P1 R4.2
P1 R4.x Changes to RS3 manuals
Section 4:
P1 R4.x Changes to RS3 manuals
This section describes changes to the following Version P1 manuals.
These changes occurred a fter the last printing of these m anuals, so
they supplement or correct the Version P1 set.
Manual
RN Page
Number
Service Manual 4-1
Site Preparation and Installation 4-13
I/O Block Configuration 4-13
SV — Pixel Board Upgrade
To upgrade the 68020 board (1984--1540--0009) use the instructions in
the paragraph titled 68020 OI PROCESSOR EPROM UPGRADE.Forthe
68040 board ( 1984--3202--0010 or 10P55270010) use the instructions
in the paragraph titled 68040 OI PROCESSOR EPROM UPGRADE
10P57801003 version instructions. Table 4.1 shows the kits for the two
types of consoles.
NOTE: T he 68020 processor board is not supported with P1.
Table 4.1. V18 and earlier/68020 Console Boot ROM and Graphics Card Requirements
OI Processor Board
Boot ROM
w/Graphics Card
1984--1540--0009 1984--2172--0927 (Ver. 9.27*) 1984--1064--0001
* The Boot ROM level X.YY is the minimum required; a higher .YY number will also work.
Table 4.2. P1 R4.x/68040 Console Boot ROM and Graphics Card Requirements
OI Processor Board
Boot ROM w/Graphics Card
1984--3202--0010 (all revs) 1984--3204--1010 (Ver 10.10*) 1984--2503--0001
1984--3202--0010 (rev F/H or newer) 1984--3204--1012 (Ver 10.12*)
1984--2503--0001 or
10P58900001
* The Boot ROM level X.YY is the minimum required; a higher .YY number will also work.