Specifications

RN: 2-33
RS3: Software Release Notes for P1 R4.2
Software and Hardware Requirements
Supervisor Computer Interface (SCI) Requirements
Table 2.32. P1 R4.x/SCI Requirements
Software Image
Processor Board OI NV Memory Boot ROM
$
$
SCIPROG
68000
(Requires a 1 MB OI
processor board)
10P57140008
OI Bubble
1984--1147--000x
1984--1167--000x
8.XX
$
$
S
C
I
P
R
O
G
1
0
P
5
7
1
4
0
0
0
8
1984--2759--0008
1984--2137--0008
OI NV RAM
1984--1547--000x
8.72
NOTE: Boot ROM level X.YY is the minimum required; a higher .YY number will also work.
RS3 Network Interface (RNI) Requirements
RNI software version 4.1 requires P1 R4.x or later software release, P1
PeerWay Image Designation only.
RNI software version 3.0 requires V18 R2.8 or later software.
RNI software version 3.0 is the minimum RNI software version that can
run on P1 R4.x software release (either PeerWay Image Designation).
RS3 Operator Station (ROS) Requirements
Refer to Table 1.3 and Table 1.4 for information about the recent Base
System software and ROS software releases.
From Table 2.1, for P1 PeerWay Image Designation, ROS 4.0.1 with
SP1 is supported. This version supports ROS ABC Batch Messaging.
From Table 2.2, for P1/V18 Combined PeerWay Image Designation,
ROS 3.1.2 is the only supported ROS release. T his release does not
support ROS ABC Batch Messaging.
RS3 VAX Interface (VAX) Requirements
If a RMT/host VAX interface is used, P1 R4.x requires VAX/VMS version
V5.5-1 or higher. RMT/host has been verified on VMS release up to
Open VMS VAX version 7.0.