Specifications

RN: 2-7
RS3: Software Release Notes for P1 R4.2
Software and Hardware Requirements
D A screen print of the Disk Directory PeerWay ( DDP) screen (or
screens if the system is large). T his screen lists all consoles that
have their own hard drives o n the system (m aster nodes). Any
consoles that are listed on the PS screen but not listed on the
Disk Directory PeerWay screen are slave nodes. Slave nodes
(consoles that share hard drives and tape drives with a master
node) have to be upgraded.
Specific Component Information
Collect the following specific information to determine the upgrade
requirements for the items listed:
Consoles
D A screen print of the first, second, and third page (the third page
only applies to a password system ) of the Configure Command
Console (CCC) screens.
D The type of tape drive and hard drive on the console. With newer
versions of software, the tape drive type can be determined from
the second page of the CCC screen (see the CCC screen field
definitions in the Console Configuration Manual). See Table 2.4
through Table 2.7 for more information on tape drives and hard
drive requirements.
NOTE: F or m ore information, reference Knowledge Base Article
#AUS1-208-000119144549.
Use Table 2.4 through Table 2.11 in the Console section to
determine if your current hardware will support P1 R4.x software.
ControlFiles
D A screen print of the ControlFile Status (CFS) screen.
D A screen print of the F ield I/O Status (FS) screen for each
controller in the ControlFile.
NOTE: Some controllers, such as the MUX, RBLC, and PLC do
not have F S screens.
D The size of the NV memory in the ControlFile. See Table 2.3 for
NV memory card identification.