Specifications
RN: 2-5
RS3: Software Release Notes for P1 R4.2
Software and Hardware Requirements
Table 2.2. Supported Peerway Node Hardware Combinations for P1/V18 Combined PeerWay
Image Designation
Consoles
ControlFiles
(1)
Future
DeltaV
Operate for
RS3
ROS MTCC
or
SMS
Coordinator
Processors
Memory Controllers Consult
Tables for
Boot ROM
and Images
No ROS 3.1.2 68040
CPIV+ or
CPIV
4MBNVRAM MPC5 Table 2.23 or
Table 2.24,
and
Table 2.29
CPIV+ or
CPIV
4MBNVRAM
or
2MBNVRAM
MPCII Table 2.25 or
Table 2.26,
and
Table 2.29
CPIV+ 2MBNVRAM MPCII
MPC(I)
CC
MLC
SSC
MUX/PLC
Table 2.27
and
Table 2.29
CPII 2MBNVRAM
or
1MBNVRAM
or
1 MB Bubble
or
.5 MB Bubble
MPCII
MPC(I)
CC
MLC
SSC
MUX/PLC
Table 2.28
and
Table 2.29
(1)
Mix of P1 and V18 Images. Consult Table 2.23 to Table 2.29.
Notes:
D
Other acceptable nodes not shown are HIA, SCI, RNI, VAX, and TRU. Consult Table 2.31 and Table 2.32
NOTE: As shown in Table 2.2 above, the use of any V18 images from
the P1 R.4.2 software release precludes the use of some the latest RS3
technology. F or example,
D
The new CP5 cannot be used with a P1/V18 Combined
PeerWay Image Designation.
D
The latest release of ROS 4.x cannot be used with a P1/V18
Combined PeerWay Image Designation.
D
The future product DeltaV Operate for RS3 cannot be used with
a P1/V18 Combined PeerWay Image Designation.
In order to take advantage of any of the above new technology, it will be
necessary to upgrade the consoles and ControlFiles to the minimum
shown in Table 2.1 for a P1 PeerWay Image Designation.
For specifics about the correct images to use for a P1/V18 Combined
PeerWay Image Designation, refer to the tables identified in Table 2.2
and the information under the heading “ControlFile Node Combinations
Supported in P1/V18 Combined PeerWay Image Designation” later in
this section.