Specifications

RN: 2-4
RS3: Software Release Notes for P1 R4.2
Software and Hardware Requirements
DeltaV Operate for RS3 lets you operate your RS3 from DeltaV
consoles. On the DeltaV screen, you can see and manipulate data and
information from RS3. DeltaV Operate for RS3 will allow current MTCC
or ROS users to migrate to newer technology. When combined with
DeltaV controllers, data from both RS3 and DeltaV equipment can be
combined on the same process graphic on the DeltaV Operate for RS3
consoles.
For specifics about the correct images to use for a P1 PeerWay Image
Designation, refer to the tables identified in Table 2.1 and the
information under the heading “ControlFile Node Combinations
Supported in P1 PeerWay Image Designation” later in this section.
RS3 Hardware Requirements for P1/V18 Combined PeerWay
Image Designation
In order to support older RS3 hardware, if any node on a PeerWay is
required to use a V18 image from the P1 R4.x software release with
nodes running P1 images, that PeerWay is defined to have a P1/V18
Combined Image Designation. Table 2 .2 below lists the supported and
compatible PeerWay Node Hardware Combinations on a P1/V18
Combined PeerWay Image Designation.