Specifications

RN: 5-84
RS3: Software Release Notes for P1 R4.2
Changes to RS3 Manuals
Service Quick Reference Guide Changes
Changes to the Service Quick Reference Guide (SQ) are a result of
additional information concerning:
D Changing of the status and detail screen names from “F IC
Status” to “F ield I/O Status” and “F IC Detail” to “ F ield I/O Detail”
D Introduction of a new MAI32 F IM with the P1 R3.4 release
The following information describes the changes to this manual.
SQ: Chapter 1 (Troubleshooting)
Description: Changes to the first paragraph on page 1-39 are a result
of a change in the name of a status screen. The name changed from
“FIC Status” to “Field I/O Status”.
Restoring Redundant FICs
When a primary FIC with redundancy fails, the redundant FIC takes
over. T he failed FIC lights its red LED or flashes its green LED. Replace
the failed FIC and determine that the new FIC has its green LED lighted
and that the F ield I/O Status screen (previously the F IC Status screen)
shows no error for the FIC. The “Health” field of the primary FIC will still
show “Bad”.
Description: Changes to page 1-52 are a result of a change in the
name of a detail screen. T he name changed from “FIC Detail” to “Field
I/O Detail”.
Field I/O Detail Screen
The Field I/O Detail screen (previously the F IC Detail screen) displays
information about the blocks that are associated with an individual FIC
or FIM. This screen is for display purposes only. To call up the Field I/O
Detail screen, cursor to the desired FIC or FIM and press [SELECT]
from the Field I/O Status screen (previously the FIC Status screen). To
view the Field I/O Detail screen for a FIC or FIM, cursor to the desired
card and press [SELECT]. If any I/O Block is in alarm the associated
FIC or F IM will be in a corresponding color. There are five groups of
status bits. The first is the same as for the Field I/O Status screen. The
next four are for points 1--4, 5--8, 9--12, and 13--16.