Specifications

RN: 5-73
RS3: Software Release Notes for P1 R4.2
Changes to RS3 Manuals
The Pixel Graphics Video Generator (10P58900001 or
1984--2503--0001) generates color video signals for the command
console CRT.
SV: Chapter 4 (ControlFiles)
SV-4: Section 2 (ControlFile Support Section)
Description: The following note was added to the bottom of page
4-2-29 under the heading “CP LEDs, Test Points, and Enable/Disable
Switch”.
NOTE: If the CP switch is disabled and then quickly enabled, the CP
may refuse to boot up. Wait for the red LED to come on before throwing
the switch again.
SV-4: Section 3 (Controller Processors)
Description: The following note was added to page 4-3 -13.
NOTE: With the MPC5, the I/O communication baud rate is set by
software instead of by a hardware jumper (as done by the M PCII and
MPC). The baud rate is set automatically when either the PLC+ or
MUX+ image is selected.
Description: The following note was added after the first bulleted
paragraph on page 4-3-36.
NOTE: Before removing the primary CP card, first disable the
Nonvolatile Memory card and the secondary CP card. For m ore
information on removing and installing cards, see SV: 9-1.