Specifications

RN: 5-47
RS3: Software Release Notes for P1 R4.2
Changes to RS3 Manuals
Tables 4.1.1. Device Error Messages for the Hard Disk
Message
Meaning Action
Hardware Error
A non-recoverable hardware failure in
the hard drive has been detected.
Check the SCSI board and cable;
replace the hard drive unit if
necessary.
Medium Error
The hard disk probably has bad
magnetic medium.
Replace the hard drive unit.
Drive Not Ready
The hard drive cannot be accessed at
the present time; the hard drive may be
doing a recalibration.
T ry the disk activity later.
Table 4.1.2. Device Error Messages for the Tape Drive
Message
Meaning Action
End of Tape
Encountered
or
End of Data
Encountered
The end of the tape / end of data was
encountered during a WRITE to the
tape drive.
or
A tape cartridge is not installed in the
tape drive.
Use a new tape cartridge.
or
Insert a tape cartridge in the tape
drive.
Tape Unloaded or Not in
Drive
A tape cartridge has been unloaded
or is not installed in the drive.
Load / Insert a tape cartridge in
the drive.
Reached Medium End of
Tape /Data
The tape drive has encountered the
end of tape / data.
Use a new tape cartridge.
Hardware Error A non-recoverable hardware failure
has been detected in the tape or hard
drive.
Check the SCSI board and cable;
replace the tape drive unit, if
necessary.
Tape May Have Been
Changed
The tape cartridge was changed prior
to the current operation.
Reload the tape from the Disk
Directory PeerWay screen.
Tape Retries Occurred
(Check Medium)
An non-recoverable data error has
been encountered in the tape
medium.
Use a new tape cartridge.
Write Attempted before End
of Data
Tape write operation Incomplete. Retry the tape operation.
Tape Write Protected or
Wrong Type
The cartridge installed in the tape
drive is write-protected.
Remove the tape cartridge and
change the protection switch
position.