Specifications

RN: 5-39
RS3: Software Release Notes for P1 R4.2
Changes to RS3 Manuals
DT-2: Page 2-4-7, Figure 2.4.2 (Disk Activity Screen: Disk
Controller Save or Backup)
Description: The name of this screen has been changed to “Disk
Controller Save or Backup.” In addition, the following lines on this
screen have been modified:
D Address Range
D Operation
D Will SAVE …
Replace the existing figure with the modified figure as shown following.
DISK ACTIVITY 03-Nov-97 11:47:12
Source Disk CCBOOT30
At Node 30 On Drive 1
Source File >SODA Plant Config
Node Range 1 to 32
Address Range >=1,2
Operation >Disk Cont Save or Backup Save Plant Configuration
Will SAVE the Plant Configuration(s) of blocks specified in Address
WARNING: This may overwrite existing blocks in the destination file.
>Press <ENTER> to Begin
File to be saved is located in the
Plant Configuration folder
Addresses to be saved—nodes 1 and 2
Node and drive indicating
location of file to be saved
File to be saved—SODA
Figure 2.4.2 Disk Activity Screen: Disk Controller Save or Backup
DT-2: Page 2--4--8, Procedure 2.4.2 (Disk Controller Save
or Backup)
Description: Update steps 5, 7, and 9 of this procedure to reflect the
screen name change to “Disk Controller Save or Backup.”
In step 5, add information to the “Response” block. In step 7, modify
information in the “Action” block and add a second Note that explains
how you can specify subsets within the node range. In step 9, modify
information in the “Action” block. T he m odified steps 5, 7, and 9 are
shown following.