Specifications

RN: 5-37
RS3: Software Release Notes for P1 R4.2
Changes to RS3 Manuals
Procedure 2.3.4. Disk Load Program or Script to FIC/FIM
Step
Operation Description
1
Action:
Response:
CAUTION
The Disk Load Program operation may affect the plant control
scheme.
Call up the Disk Directory PeerWay screen by typing:
DDP [ENTER]
The Disk Directory PeerWay screen appears.
2
Action:
Response:
Cursor to the disk volume name or location containing the FIC/FIM program, and
press [SELECT ].
The Disk Directory screen appears.
3
Action:
Response:
Cursor to the Plant Program folder name, and press [SELECT].
The Plant Prog Directory screen appears.
4
Action:
Response:
Cursor to the name of the file to be loaded ($$AFIC), and press [ENTER].
The Disk Activity screen appears.
5
Action:
Response:
Cursor to the “Operation” field on the Disk Activity screen. Press the [NEXT
OPTION] button repeatedly until the following message appears above the
“Operation” field:
Disk Load Program or Script
Press [ENTER].
The “Disk Load Program or Script” then appears in the “Operation” field. The
“Download to FIC Card(s)” field appears, indicating that the proper file was
selected.
6
Action: Cursor to the “FIC Addr Range” field. Enter the address of the FIC to which the
program is to be loaded. For example, 33AA1, 33AA2 specifies that the FIC
program is to be loaded to FICs located at 33AA1 and 33AA2. Press [ENTER].
7
Action:
Response:
Comments:
Cursor to the “Press <ENTER> to Begin” field, and press [ENTER].
While the operation is in progress this field reads:
Disk Operation in Progress
The operation is complete when the “Press <ENTER> to Begin” field reappears.
The operation may take several minutes to complete. To load all FICs attached to a
Controller Processor takes about 1
1
/
2
minutes. If several Controller Processors are
being loaded, they are loaded in alphanumeric order.
(continued on next page)