Specifications

RN: 5-35
RS3: Software Release Notes for P1 R4.2
Changes to RS3 Manuals
DT: Chapter 2 (Procedures)
DT-2: Section 4 (Saving)
Description: The Console Configuration screen in F igure 2.1.5 was
changed to include the ‘Host’ field for ABC Batch M essaging (page
2-1-12).
CONSOLE CONFIGURATION 25- Feb-96 12:07:37
This is Node 32 MTCC Date → 25-Feb-96 Time →12:08:36
Prgm Revision P1.02 PX ENG 68040 MTCC
Boot Revision 11.08 Peerway # ⇒2 Slot width ⇒30
Last Restarted 24-Dec-95 09:02:47
Logs: Batch >Disable Maint >Disable Time Correction →.00 Sec./day
Alarm >Disable Op Chg ⇒Disable Host >Disable
ASCII Keyboard >Configuror Reboot Menu →13
Key Click >yes Keyclass for Ignore Interlock >SUPER
Mark Key >no
Graphics Menu Key >no Keyclass for Loop Tuning >SUPER
Speaker Volume →Med
Alarm Speaker →yes Keyclass for Reports ⇒OPER
Grp Blk ID for Oper →descriptors Printer/Modem Config
Tags or Addresses ⇒yes
PID Proportional ⇒Gain Printer ⇒Fujitsu L/Pg ⇒66
Tape Auto Load ⇒no
Configuration File Baud ⇒4800 Print Node ⇒28
Name Update ⇒yes Autodial ⇒no FF ⇒yes >Reset
Volume Name : TMP
File Name : GRP-WDAY1
Press [ENTER] to change Tape
Auto Load from “no” to “yes”.
Figure 2.1.5. Console Configuration Screen: Tape Auto Load
Description: The subsection “Loading the FIC Program Image to the
FIC” on page 2-3-10 was changed to “Loading the FIC/FIM Program
Image to the FIC/FIM” and the information included under this title was
changed to read as follows.
The Disk Load Program or Script disk operation loads the F IC/FIM
program image to the F IC/FIM.
The FIC/FIM program image is stored in the Plant Program folder. T he
FIC/FIM program image files that can be loaded with this procedure
include $$AFIC, $$T F IC, $$DIO, and $$MAIO.
Figure 2.3.2A shows the F IC program image being loaded to the FICs.