Specifications

RN: 5-34
RS3: Software Release Notes for P1 R4.2
Changes to RS3 Manuals
The memory in the Controller is volatile, so if the Controller is disabled,
the configuration is gone from the Controller, but not from the NV
Memory. The NV Memory utilizes non-volatile battery backup memory.
All plant configurations from the Controllers are retained even if the
board is removed from the ControlFile. Loss of setpoint data can only
occur under a specific set of circumstances. If the Controller is disabled
and the NV Memory backup batteries are disabled, then the plant
configuration will be lost. If the Controller is left active or the NV Memory
is operational, the plant configuration will be retained in the system.
DT-1: Section 3 (Disk Activity Screens)
Description: Information on the “Mode” and “Backup Pattern” fields
was added to Figure 1-3-1 on page 1-3-1.
DISK ACTIVITY 23-Jul-98 11:47:12
Source Disk xxxxxxxx
At Node xx On Drive x
Mode >XXXXXXX XXXX
Backup Pattern >XXXXXXXXX
Operation >XXXXXXXXXX
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
WARNING: XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
⇒Press <ENTER> to Begin
Pressing [ENTER] begins
the specified operation
Operation to be performed.
[NEXT OPTION] key selects the
volume operation to be performed
Current date
Node and drive on which
the volume is located
Name of the currently
selected volume
Current time
Screen title
Any warnings
concerning the
operation appear here
Brief explanation
of the operation
“Single Tape” or “Multiple
Tape”, as needed
Gives you the option of
backing up only the files
that have a specific
character string
Figure 1.3.1. Disk Activity Screen Common Fields