Specifications

RN: 5-28
RS3: Software Release Notes for P1 R4.2
Changes to RS3 Manuals
CB: Chapter 9 (Data Compression)
CB-9: Section 3 (Configuring Compressors in a Data
Compression Block)
Description: The following note was added after the paragraph on
page 9-3-1.
NOTE: Do not perform engineering units (EU) conversion for Data
Compression block (DCB) inputs on the Continuous Links screen.
Instead, set EU conversion on the register that the DCB input is linked
to. T he DCB will then operate with a scaled value, and that value in the
source block will also be scaled.
Disk and Tape Functions Manual Changes
Changes to the Disk and Tape Functions Manual (DT) are a result of:
D Introduction of the 2.1 GB hard disk.
D Additional information on tape drive location labels
D Introduction of the Tandberg TDC 3660 tape drive with the P1
R1.1 release
D Introduction of the MPC5 Controller Processor with the P1 R3.0
release
D Introduction of ABC Batch Messaging with the P1 R3.4 r elease
D Automatic backup functionality added
D Master License Agreement
D Device error message changes
The following information describes the changes to this manual.
DT: Chapter 1 (Media & Screens)
DT-1: Section 1 (Disk and Tape Media)
Description: Information on the 2.1 GB hard disk was added to
Table 1.1.1 on page 1-1-2.