Specifications

RN: 5-25
RS3: Software Release Notes for P1 R4.2
Changes to RS3 Manuals
ControlBlock Configuration Manual Changes
Changes to the ControlBlock Configuration Manual (CB) are a result of:
D Introduction of the MPC5 Controller Processor with the P1 R3.0
release
D Allowable entries for the Prop Band field
D The values for the TOT function input and output registers
The following information describes the changes to this manual.
CB: Chapter 1 (Introduction to ControlBlocks)
CB-1: Section 1 (what is a ControlBlock?)
Description: The first bulleted item and Figure 1.1.3 on page 1-1 -4
were modified to include the MPC5.
D Up to 126 blocks for an MPCII or an MPC5
ControlBlock Number
01 -- 126 MPCII / MPC5
01 -- 99 MPCI
(This does not correspond to
a physical address.)
Dash
(Differentiates the ControlBlock from an I/O Block)
Controller Processor Address
=16A -- 12
Figure 1.1.3. ControlBlock Addressing
CB: Chapter 2 (Configuring ControlBlock Functions)
CB-2: Section 2 (Configuring PID Functions)
Description: The allowable entries were changed for the Prop Band
field in Table 2.2.5 on page 2-2 -16.