Specifications

RN: 5-20
RS3: Software Release Notes for P1 R4.2
Changes to RS3 Manuals
CC: Chapter 6 (Alarm Management)
Section 3 (Separating and sorting Alarms at a Console)
Description: The field “F lush Block Cache” was added to Figure 6.3.2
and to Table 6.3.3 (pages 6-3 -9 and 6-3-10).
ALARM LIST CONFIGURATION 01-Aug-96 11:44:24
+---Print---+
List Type Size Trigger Node
↓
Hardware ⇒200 ⇒50 ⇒32 Flush Block Cache
Process ⇒200 ⇒100 ⇒20 External Alarm ⇒NC
Batch ⇒200 ⇒50 ⇒20 Backup Printer Node ⇒20
System Status ⇒100 ⇒50 ⇒32 Restore Primary Printer Nodes
Disk Events ⇒50 ⇒25 ⇒32 Alarm Print⇒Normal
Operator Log ⇒100 ⇒50 ⇒32 Last Initialize Time
28-Oct-95 07:11:38
Suppressed 2860 ** **
Total Entries (All Lists, including Events) 3850
⇒Initialize Lists (press ENTER)
WARNING: This will Clear ALL Alarm and Event Lists
FULL CONFIG 1
-
To call up:
D ALC[ENTER]atthe
command line
The difference between the “Total Entries” size
and the sum of the configured alarm type list
and event list sizes is automatically reserved for
the suppressed alarm lists.
Shows the maximum number of
alarms and events that can be
stored in console RAM.
-
To change an entry:
1. Cursor to the field, type in the new entry, and press [ENTER].
New entries are displayed in a contrasting color.
2. The changes do not take effect until you initialize all the lists.
When you have made all the changes to the screen that you
want, initialize the list by cursoring to the “Initialize Lists” field
and pressing [ENTER].
NOTE: This will clear all alarm and event lists.
-
To access other screens:
D [PAGE AHEAD] to see Event List
Configuration
D [PAGE BACK] to see Automatic Alarm
Deletion
Figure 6.3.2. Alarm List Configuration Screen