Specifications

RN: 5-13
RS3: Software Release Notes for P1 R4.2
Changes to RS3 Manuals
D Graphic files in the Process Graphics folder
D Report configuration files in the Report Configuration folder
D Group Display configurations in Console Configuration files
D Trend configurations in Console Configuration files
D Trend Display configurations in Console Configuration files
NOTE:
D When blocks are copied using the Plant Configuration “Disk Load
Transfer”, remember to change any duplicate tags.
D The Link Editor changes only references to block links in the
configuration. It has no effect on actual block links in the
specified controllers.
D Yo u cannot change the range of an I/O card cage.
Example: Address Range =1CA120,130
New Address =2CA101 will not work
Modifying a Configuration File
The Link Editor allows you to update the addresses within a
configuration file. T he file is modified to reflect the new addresses for
the address range that is modified for all functions.
NOTE: Always make a copy of your original file, and work from the
copy.
Yo u must be careful when loading the Console Configuration m odified
file. The suggested procedure is to load in this order:
1. Load the full Console Configuration for the desired file on the
Disk Activity screen.
2. Save the Console Configuration using the “All” function on the
Disk Activity screen.
3. Verify that the “ Configuration F ile” on the lower left corner of the
“Configure Command Console” screen is updated so that the
console will load the correct file the next time the console is
rebooted.
Modifying Other RS3 F ile T
ypes
Other RS3 file types within the system cannot be changed using the
Link Editor, however each can be modified in another manner:
D Plant Configuration
Modified using ”Disk Load Transfer” function on the Disk Activity
screen, or using the PC-based Control Studio application.
D Batch Tasks