Specifications

RN: 5-9
RS3: Software Release Notes for P1 R4.2
Changes to RS3 Manuals
Console Config
Controls automatic console configuration backup.
D Console Config: field toggles between Enable and Disable.
D Destination File field must be configured by the user before the
automatic console configuration operation can be enabled.
D Event Type field requires selection of an event number from 0
to 240, to trigger the automatic console configuration backup.
See page 2--1--28 for more information on automatic console
configuration backup.
Logs:
Batch
Alarm
Maint
Op Chg
Host
Specifies whether or not the particular log is enabled or disabled.
Press [ENTER] to change the entry.
Batch = Batch log
Alarm = Alarm log
Maint = Smart transmitter maintenance log
Op Chg = Operator change log
Host = ABC batch messaging
Note: Do not change the Host field to “Enable” mode unless you are
using the ABC Batch Messaging function to send Batch messages to
the RS3 Operator Station Journal. See the ROS Getting Started
Manual for more information.
Plant Config
Controls automatic plant configuration backup.
D Plant Config: field toggles between Enable and Disable.
D Backup File field always specifies $$BACKUP as the backup
file. The $$BACKUP file must exist before the automatic plant
configuration operation can be enabled.
D Event Type field requires selection of an event type number
from 0 to 240, to trigger automatic plant configuration backup.
See page 2--1--28 for more information.
CC-2: Section 2, Table 2.1.2, (Console Configuration
Screen Fields)
Description: Add new tape drive type (Tandberg) to this table as
shown.
Field Description
Tape Drive Type
Displays the tape drive on a console acting as a Master Node.
Possible displays are:
D RS3*T1 45S (Scorpion qic--24 format)
D RS3*T2 60S (Viper 2060S qic--24 format)
D RS3*T3 150S (Viper 2150S qic--150 format)
D RS3*T4 TDC 3660 (Tandberg 3660 qic--150 format)
For more information about tape drive types and specifications, see
DT:1.