Specifications

RN: 5-5
RS3: Software Release Notes for P1 R4.2
Changes to RS3 Manuals
Alarm 419 will occur normally on all disk-only consoles.
419
No Tape or
Floppy Disk Drive
Found
Occurs when the RS3 cannot detect the presence of
a tape or floppy drive. You should check your cable
connections.
This error may also occur when a disk-only (040)
console is the only storage media present. In this
case, the error is merely a verification of that
hardware.
S Disk
775
Start Memory
Dump cont: <nn>
A manually initiated memory dump of Controller
Processor <nn> has been started.
D Disk
776
Finish Memory
Dump cont: <nn>
A manually initiated memory dump of Controller
Processor <nn> has been completed. The memory
dump takes about twenty minutes.
D Disk
777
Kill Memory
Dump cont: <nn>
The manually initiated memory dump of Controller
Processor <nn> has been killed.
D Disk
801
Auto Plant Config
Backup File Not
Found
The $$BACKUP file was not found at the time a
backup was to be performed.
D Console
811
Controller Image
Checksum Test
Failed
The MPC5 controller image checksum test failed.
The controller will be reset and the image reloaded
from NV memory.
H ControlFile
Console Configuration Manual Changes
Changes to the Console Configuration Manual (CC) are a result of:
D Support for the Tandberg TDC 3660 tape drive released with P1
R1.1
D Addition of automatic backup capability with the P1 R1.2 release
D Batch support on SMS released with the P1 R1.2
D Link Editor changes released with P1 R1.2
D Support of ABC Batch M essaging (ABM) r eleased with P1 R3.3
The following information describes the changes to this manual.
CC: Chapter 2 (Configuring Operating Characteristics)
CC-2: Section 1
Description: Add “ Automatic backup functions” to the list of topics,
following “Configuring 16-character block tags” on page 2-1-1.
D Automatic backup functions