User`s guide

PAGE 3
MAXTOR ONETOUCH III MINI EDITION WINDOWS INSTALLATION
Installing the OneTouch III Mini Edition
Step 1 – Connect the Drive
1. Connect the small connector on the ‘Y’ cable to your
OneTouch III Mini Edition and the red connector to any one
of the USB ports on your computer.
Note: If your computer does not supply enough power to
the OneTouch III Mini Edition through the red connector,
plug in the unused black connector on the ‘Y’ cable to
another USB port on your computer (or a powered USB
hub).
If both ports fail to supply enough power to the drive, an
optional power supply should be purchased from Maxtor at
www.maxstore.com
FIGURE 3 CONNECTING THE ONETOUCH III MINI EDITION
Step 2 – Install the Software
The installation software is located on the OneTouch III Mini
Edition. The following steps will guide you through the
installation procedure.
Highly Recommended – Copy all files on the OneTouch III Mini
Edition to your local hard drive.
1. Click Start 

Run . Browse to the drive letter used for the
OneTouch III Mini Edition’s drive letter and open
Launch.exe .
2. From the Run window, click OK .
Note: If an Autoplay window opens for the drive, select
Open folder to view files, click OK and then double-click
Launch.exe.
3. The following window displays. Select your Language .
Small
Connector
Red
Connector
Black
Connector