Product manual
Table Of Contents
- 1.0 Introduction
- 2.0 Drive specifications
- 2.1 Specification summary table
- 2.2 Formatted capacity
- 2.3 Default logical geometry
- 2.4 Recording and interface technology
- 2.5 Physical characteristics
- 2.6 Seek time
- 2.7 Start/stop times
- 2.8 Power specifications
- 2.9 Environmental specifications
- 2.10 Acoustics
- 2.11 Electromagnetic immunity
- 2.12 Reliability
- 2.13 Agency certification
- 2.14 Environmental protection
- 2.15 Corrosive environment
- 3.0 Configuring and mounting the drive
- 4.0 ATA interface
- 5.0 Seagate Technology support services
DB35.3 Series PATA Product Manual, Rev. B
iii
List of Figures
Figure 1. Typical 5V startup and operation current profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Figure 2. Typical 12V startup and operation current profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Figure 3. Breather filter hole location. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
Figure 4. Master/slave jumper settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
Figure 5. Ultra ATA cable connectors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24
Figure 6. Mounting dimensions—top, side and end view . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25
Figure 7. I/O pins and supported ATA signals . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27