User`s manual

ARS-2017E Manual

4.2.2 IDE Hard Drive Connection

Figure 4-2

Before connecting an IDE hard drive to the tray of ARS-2017E, you need to set the

hard drive as “Master” or “Cable Select” mode by adjusting the jumper setting. If the

hard drive contains important data, please back up your data first, and then put the

hard drive into the tray so as to ensure the highest data security. Besides, if you

want to install the current hard drive which contains OS into ARS-2017E in order to

boot the OS there, see Appendix 1.

l In replacing a hard drive, be sure that ARS-2017E is ON, or the new

drive might be regarded as source drive, and the data in the old drive

might be covered.

DIP Switch

SCSI Connectors

The auto-eject handle of the tray

HDD Tray

Power Switch

Power Cord Connector