User`s manual

16
ARS-2017E Manual
the screen to warn the system manager, and so the temperature will be
recorded to the event log.
2.2.4 Warning alarm : enable warning alarm
When the system becomes abnormal, the buzzer will be activated to warn
the system manager.
2.3 Display Opt. : the setting of LCD
2.3.1 Standby time : set the time for the system to return to standby mode
If the system idle time is over the set value, the system will return to
standby mode.
2.3.2 Page switch rate : set the rate of information switching
It is to set the interval rate of displaying information in standby mode.
2.3.3 Info update rate : set the rate of information update
It is to set the update rate of the system status.
2.3.4 Temperature unit : set the unit of temperature
It is to set the temperature unit as °C or °F.
2.3.5 Key tone : set the sound of key pressing
It is to enable or disable the sound of key pressing.
3.ADVANCED SETUP : the settings of the advanced functions
Press ▲ or ▼ to change the option. Press ENT to confirm your option.
3.1 Mirror size : the setting of Mirror capacity
3.1.1 Set maximum : set the maximum capacity
3.1.2 Extend size : extend the size of Mirror
When the two hard drives of the original system have been changed, and
the capacity is bigger than the present Mirror, you are allowed to execute
this function to extend the size of Mirror. The newly increased capacity will
be indicated by the second partition.
3.2 Compare : compare the data
It is to compare if the two hard drives’ data are the same. During compa-
rison if there is any difference, the system will start to rebuild the remaining
data from the primary hard drive to the secondary one. Once this function is
activated, the menu will change to “Stop compare” automatically so that the
system manager can stop comparison.