User`s guide

FCAL Drive Module
6
Note Removal Is the reverse of this procedure (press on the indentation to release the latch).
1.4 Engaging the Anti-tamper Locks
The anti-tamper locks are fitted in the drive carrier handles and are accessed through the small rectangular cutout
in the lower part of the handle trim piece.
Drives are supplied with the locks set in the unlocked position.
1.4.1 Activating the Locks
1 Carefully insert the lock key provided into the cutout in the handle trim.
2 Locate the key into its socket.
3 Rotate the key through 90 degrees in an anti-clockwise direction until the indicator visible in the centre aperture of
the handle shows green.
).
4 Remove the key.
Figure 1–7 Installing an FC-AL Drive Carrier Module (4)
Figure 1–8 Activating the Anti-tamper Lock
Indicator Aperture
To lock turn 90º
anti-clockwise