User`s guide

SS-1200-FCAL User Guide
36
4.9.2 ESI/Ops Panel Module
4.9.2.1 Removing the Module
Important This module is designed for Hot Plug replacement. In order to ensure that there is no loss of
system availability during replacement, the enclosure DEFAULT state with the ESI module
removed is Power On.
1 Release the catch on the side of the ESI/Ops Panel module.
2 Grip the front panel surround or the key (turned to the Service position0 firmly and slide the unit out of the enclosure
bay.(Figure 4–4)
3 The subsystem must not be run for extended periods without the ESI/Ops Panel module being in place.
Figure 4–3 Fitting the Grounding Screw
Figure 4–4 Removing an ESI/OpsPanel Module (Front Mounting)