User`s guide

SS-1200-FCAL User Guide
30
For details on how to remove and replace a module see Section 4.9.
Warning Whenever replacing a module NEVER leave an EMPTY space in the rear of the enclosure, obtain
a replacement before removing the problem part.
4.3 Audible Alarm
The Operator Panel also includes an Audible Alarm which indicates when a fault state is present. The following
conditions will activate the Audible Alarm:
•Drive Fault
•Fan slow
• Voltage out of range
• Over temperature
• Thermal overrun
• UPS two minute warning
• System fault
Power/ Cooling Power off/
Standby
All PSUs & Fans
OK
Not Used Any PSU or Fan
fault
4.5.2
UPS Status
Not used on FC-AL Enclosure
Standby No AC supply Standby OR
Power good
Not Used Machine in
Standby due to
ESI Thermal
Shutdown
4.5.4/
4.5.5
Figure 4–1 Ops Panel LEDs and Switches
Table 4–1 Ops Panel LED Status
LED Off Green Steady Green/Amber
Flashing
Amber Steady Section
Ref No.
System Drive Power/Cooling UPS Standby
Run/ServiceAlarm MuteSecuring Latch