Product manual

18 Barracuda 9FC Product Manual, Rev. C
6.2.1 Conducted noise immunity
Noise is specified as a periodic and random distribution of frequencies covering a band from DC to 10 MHz.
Maximum allowed noise values given below are peak-to-peak measurements and apply at the drive power
connector.
6.2.2 Power sequencing
The drive does not require power sequencing. The drive protects against inadvertent writing during power-up
and down.
6.2.3 12V current profile
Figure 3 identifies the drive +12V current profile. The current during the various times is as shown:
Figure 3. Typical Barracuda 9FC drive +12V current profile
T0 Power is applied to the drive.
T1 Controller self-tests are performed.
T2 Spindle begins to accelerate under current limiting after performing internal diagnostics.
T3 Spindle is up to speed and the Head-Arm restraint is unlocked.
Note. All times and currents are typical. See Table 1 for maximum starting and operating current require-
ments.
6.3 Power dissipation
Typical seek power dissipation is 18.3 watts (62 BTUs per hour) of DC power average at nominal voltages. Typ-
ical power dissipation under idle conditions is 16.7 watts (57 BTUs per hour).
6.4 Environmental limits
Temperature and humidity values experienced by the drive must be such that condensation does not occur on
any drive part. Altitude and atmospheric pressure specifications are referenced to a standard day at 58.7°F
(14.8°C). Maximum wet bulb temperature is 82°F (28°C).
+5V +12V (with spindle motor not running)
0 to 100 kHz 150mV 150mV
100 kHz to 10 MHz 100mV 100mV
T0 T2
0.0 2 4 6 8 10 12
0.0
0.5
1.0
1.5
2.0
2.5
3.0
TIME (S)
+12V CURRENT (A)
T1 T3
Min AC
Peak DC
Peak AC