User Manual

SCSI Commands Reference Manual, Rev. J 62
www.seagate.com General Concepts
1C 83 Seagate Unique Diagnostic Code
1D 00 Miscompare During Verify Operation E
1F 00 Number of Defects Overflows the Allocated Space That The Read Defect Command Can Handle 1
20 00 Invalid Command Operation Code 5
20 F3 Invalid linked command operation code 5
21 00 Logical Block Address Out Of Range D
24 00 Invalid Field In CDB 5
24 01 Illegal Queue Type for CDB (Low priority commands must be SIMPLE queue) 5
24 F0 Invalid LBA in linked command 5
24 F2 Invalid linked command operation code 5
24 F3 Illegal G->P operation request 5
25 00 Logical Unit Not Supported 5
26 00 Invalid Field In Parameter List 5
26 01 Parameter Not Supported 5
26 02 Parameter Value Invalid 5
26 03 Invalid Field Parameter—Threshold Parameter 5
26 04 Invalid Release of Active Persistent Reserve 5
26 05 Fail to read valid log dump data 5
26 97 Invalid Field Parameter—TMS Firmware Tag
26 98 Invalid Field Parameter—Check Sum
26 99 Invalid Field Parameter—Firmware Tag
27 00 Write Protected 7
29 00 Flashing LED occurred 4
29 00 Power On, Reset, Or Bus Device Reset Occurred 6
29 01 Power-On Reset Occurred 6
29 02 SCSI Bus Reset Occurred 6
29 03 Bus Device Reset Function Occurred 6
29 04 Internal Reset Occurred 6
29 05 Transceiver Mode Changed To Single-Ended 6
29 06 Transceiver Mode Changed To LVD 6
29 07 Write Log Dump data to disk successful OR IT Nexus Loss 6
29 08 Write Log Dump data to disk fail 6
29 09 Write Log Dump Entry information fail 6
29 0A Reserved disk space is full 6
29 0B SDBP test service contained an error, examine status packet(s) for details 6
29 0C SDBP incoming buffer overflow (incoming packet too big) 6
29 CD Flashing LED occurred. (Cold reset) 6
29 CE Flashing LED occurred. (Warm reset) 6
2A 01 Mode Parameters Changed 6
2A 02 Log Parameters Changed 6
Table 29 Additional Sense and Additional Sense Qualifier codes
ASC (byte
12)
ASCQ (byte
13)
Description Sense
Key