User Manual

SCSI Commands Reference Manual, Rev. J 425
www.seagate.com Parameters for direct access devices
CCF_IDLE field
The Check Condition From idle_c processing control (CCF_IDLE) field is defined in Table 399.
CCF_STANDBY field
The CHECK CONDITION From Standby (CCF_STANDBY) field is defined in Table 400.
CCF_STOPPED field
The CHECK CONDITION if from stopped (CCF_STOPPED) field is defined in Table 401.
Table 399 CCF_IDLE field
Code
00b
01b
10b
11b
Restricted
[a]
If the transition was from an idle_c power condition, returning CHECK CONDITION status is disabled.
[b]
If the transition was from an idle_c power condition, returning CHECK CONDITION status is enabled.
[b]
Reserved
[a] See SAS-3 for command processing in the Active_Wait state and Idle_Wait state.
[b] For direct-access block devices see the Active_Wait state in SBC-4 for the definition of command processing in that state.
For devices that are not direct-access block devices, see the state in (SPC-5) for the definition of command processing in
that state.
Table 400 CCF_STANDBY field
Code
00b
01b
10b
11b
Restricted
[a]
If transition was from a standby power condition, returning CHECK CONDITION status is disabled.
[b]
If transition was from a standby power condition, returning CHECK CONDITION status is enabled.
[b]
Reserved
[a] See SAS-3 for command processing in the Active_Wait state and Idle_Wait state.
[b] For direct-access block devices see the Active_Wait state in SBC-4 for the definition of command processing in that state.
For devices that are not direct-access block devices, see the state in (SPC-5) for the definition of command processing in
that state.
Table 401 CCF_STOPPED field
Code
00b
01b
10b
11b
Restricted
[a]
If the transition was from a standby power condition, returning CHECK CONDITION is disabled.
[b]
If the transition was from a standby power condition, returning CHECK CONDITION is enabled.
[b]
Reserved
[a] See SAS-3 for command processing in the Active_Wait state and Idle_Wait state.
[b] For direct-access block devices see the Active_Wait state in SBC-4 for the definition of command processing in that state.
For devices that are not direct-access block devices, see the state in (SPC-5) for the definition of command processing in
that state.