User Manual

SCSI Commands Reference Manual, Rev. J 209
www.seagate.com Direct Access Block commands (SPC-5 and SBC-4)
3.42.2.5 Security compliance information description
3.42.2.5.1 Security compliance information overview
The security compliance information parameter data contains information about security standards that apply to this SCSI target
device.
If the SECURITY PROTOCOL field is set to 00h and the SECURITY PROTOCOL SPECIFIC field is set to 0002h in a SECURITY
PROTOCOL IN command, then the parameter data shall have the format shown in
SECURITY COMPLIANCE INFORMATION LENGTH field
The SECURITY COMPLIANCE INFORMATION LENGTH field indicates the total length, in bytes, of the compliance descriptors that follow.
Each compliance descriptor (see 3.42.2.5.2) contains information about a security standard that applies to this SCSI target device. Compliance
descriptors may be returned in any order.
The total data length shall conform to the ALLOCATION LENGTH field requirements (see 2.2.6). Pad bytes may be appended to meet this length.
Pad bytes shall have a value of 00h.
Table 178 Certificate data SECURITY PROTOCOL IN parameter data
Bit
Byte
7 6 5 4 3 2 1 0
0 (MSB)
SECURITY COMPLIANCE INFORMATION LENGTH (m-3). . .
3 (LSB)
4
Compliance descriptor [first]. . .
. . .
Compliance descriptor [last]. . .
m
m + 1
Pad bytes (optional). . .
n