User Manual

SCSI Commands Reference Manual, Rev. J 172
www.seagate.com Direct Access Block commands (SPC-5 and SBC-4)
Table 138 Diagnostic Fault Codes
Code Fault description
01h
Formatter Diagnostic Error
02h
Microprocessor RAM Diagnostic Error
04h
No Drive Ready
08h
No Sector or Index Detected
09h
Fatal Hardware Error While Doing Drive Diagnostics
0Ch
No Drive Command Complete
10h
Unable to Set Drive Sector Size
14h
Unable to Clear Drive Attention
18h
Unable to Start Spindle Motor
20h
Unable to Recal Drive
30h
Unable to Send Write Current Data to Drive
34h
Unable to Issue Drive SEEK Command
40h
Unable to Read User Table From Drive
41h
Ran Out of Sectors While Doing Drive Diagnostics
42h
Unable to Read Reallocation Table
43h
Unable to Read ETF Log
45h
Firmware Read from disk or Sent by Host has an Invalid Checksum
60h
Thermal Calibration Failure
70h
Microprocessor Internal Timer Error
80h
Buffer Controller Diagnostic Error
81h
Buffer RAM Diagnostic Error
C1h
Data Miscompare While Doing Drive Diagnostics