User Manual

How to Use Boston Valve

1. Double valve cap (valve lets air in, not out).

2. Quick deflation cap.

3. Unscrew Double valve cap.

4. Insert output end of ait pump into valve and fill. Do not over inflate or use hight

pressure compressor.

5. To deflate: unscrew quick-deflation cap. CAUTION: Double valve does not operate

when this cap is off. Do not unscrew this cap whole boat or inflatable is in water.

Set Installation (Certain Models)

1. Inflate each seat cushion slowly about 75% of its capacity.

2. Finish inflating the sea cushion slowly until it is firm to the touch but NOT hard.

DO NOT OVER INFLATE!

3. To disassemble the seats, deflate the seats first and reverse the installation

procedures.

4. Some seat cushions after inflation are tuck in directly into the fore, mid or aft

locations of the kayak cockpit.

Paddle Assembly

1. Press and align the push-bottom on the shaft´s shrink end with the hole on

another shaft, ensure the push-bottom is securely snapped onto the holes. Do it

in three places, see figure below for details.

2. To disassemble, reverse the assembly steps.