Operating instructions

19
1. Engine drain hose (crankcase cooling outlet)
Continue to pour until antifreeze flows
in air compressor water outlet hose.
1. Air compressor water outlet hose
The pouring operation is over.
Remove pinchers in this order to allow
proper flow of antifreeze.
NOTE: Most of the antifreeze will drain
out when removing the hose pinchers.
Use a container to recover it. DISPOSE
ANTIFREEZE AS PER YOUR LOCAL
LAWS AND REGULATIONS.
1. Bleed outlet hose.
2. Engine drain hose (crankcase cool-
ing cover outlet).
3. Engine cylinder drain hose.
4. Water outlet hose.
5. Water inlet hose.
Install a temporary hose on the open
fitting of the water regulator valve.
Pour approximately 200 mL (7 oz) of
antifreeze in the temporary hose to al-
low antifreeze flowing through the wa-
ter regulator valve and into muffler to
protect it.
Remove temporary hoses and recon-
nect the factory hose to water regula-
tor valve.
NOTE: Although antifreeze will mainly
drain out, the antifreeze has mixed with
the water that was possibly trapped in
the water jackets and thus preventing
freezing problems.
At pre-season preparation, drain the
remaining antifreeze from cooling sys-
tem prior to using the watercraft. En-
sure no hose pincher was forgotten at
storage.
The following steps should be per-
formed to provide the watercraft en-
hanced protection.
F08E0JY
1
F08E0EY
1
smo2003-004b.fm Page 19 Wednesday, January 22, 2003 11:41 AM