Operating instructions

18
Hose Disconnection
Disconnect the bottom hose at the wa-
ter regulator valve on muffler.
1. Disconnect the bottom hose from water
regulator valve
Temporarily install a hose of approxi-
mately 1 m (3 ft) in length with a
12.7 mm (1/2 in) internal diameter over
the previously disconnected hose.
Antifreeze
Insert a funnel into the temporary
hose.
Ensure to hold the funnel approximate-
ly 1 m (3 ft) above the deck when pour-
ing the antifreeze to create enough
pressure so that it flows properly.
A. 1 m (3 ft) to ease antifreeze flow
Pour antifreeze mix in engine until the
colored solution appears at cooling
system bleed outlet.
At this point, install a hose pincher on
bleed outlet hose.
1. Bleed outlet hose
Continue to pour until antifreeze ap-
pears at the engine drain hose (crank-
case cooling outlet). Then, install a
hose pincher on this hose.
F08E0SY
1
F08E0TY
A
F08E0MY
1
smo2003-004b.fm Page 18 Wednesday, January 22, 2003 11:41 AM