Operating instructions

63
Models without a Flushing
Connector in Engine Compartment
Connect a garden hose to connector
located at the rear of watercraft on jet
pump support. Do not open water tap
yet.
NOTE: An optional quick connect adapt-
er can be used (P/N 295 500 473). No
hose pincher is required to flush engine.
TYPICAL
1. Hose adapter
2. Quick connect adapter
(optional, not mandatory)
3. Garden hose
Models with a Flushing Connector
in Engine Compartment
This flushing connector allows flushing
while watercraft is on a lift or if you pre-
fer to flush from this location. Either
flushing connector can be used to flush
the exhaust cooling system. The one at
the jet pump support (see above) or the
one in the engine compartment (see
below).
Remove seat to gain access.
1. Flushing connector
2. Dust cap
Remove dust cap from flushing con-
nector and attach coupler hose (sup-
plied in rear storage compartment).
Make sure coupler hose is properly
locked to flushing connector.
Install a hose pincher (supplied inside
tool kit in rear storage compartment)
on water outlet hose.
NOTE: This prevents water from di-
rectly exiting exhaust cooling system.
1. Coupler hose
2. Hose pincher
F07E01Y
3
21
1
F18E1TY
2
1
F18E1UY
2
smo2003-003a.book Page 63 Tuesday, August 27, 2002 9:23 AM