Operating instructions

40
On some models, an additional flush-
ing connector is located in engine com-
partment to allow flushing while water-
craft is on a lift or if you prefer to flush
from this location, either flushing con-
nector can be used to flush the exhaust
cooling system. Remove seat to gain
access.
1. Flushing connector
2. Dust cap
Refer to POST-OPERATION CARE sec-
tion for proper use.
27) Bilge Drain Plugs
Should water be found in the bilge, it
can be easily drained by unscrewing
the drain plugs when engine is off and
watercraft is out of water.
CAUTION: Remove boat from water
prior to unscrewing drain plugs.
TYPICAL
1. Drain plugs
2. Tighten
3. Unscrew
Tilt the watercraft slightly to the rear
so that the water can completely flow
out of the bilge.
It is suggested to drain bilge on a ramp.
CAUTION: Make sure drain plugs are
properly secured prior to launching
the watercraft in water.
28) Jet Pump Nozzle
Jet pump nozzle turns side to side via
rider input at the handlebar. This pro-
vides directional control when engine
is running.
F18L0TY
1
F18E1TY
2
F18L14Y
1 1
2 3
smo2003-003a.book Page 40 Tuesday, August 27, 2002 9:23 AM