Specifications

98
Install a hose pincher just below T-fitting.
TYPICAL
1. Hose pincher below T-fitting
Pour approximately 300 mL (10 oz) of
antifreeze in the water regulator valve
supply hose to allow antifreeze flow-
ing through the valve and into muffler
to protect it.
Reconnect hose to T-fitting and re-
move hose pincher (if applicable).
Remove temporary hose (on 717 en-
gines) and reconnect engine water out-
let hose.
Remove remaining hose pinchers.
NOTE: Most of the antifreeze will drain
out when removing the hose pinchers.
Use a container to recover it. DISPOSE
ANTIFREEZE AS PER YOUR LOCAL
LAWS AND REGULATIONS.
DI Models
Hose Pinchers Installation
Some hoses have to be plugged to
prevent draining, before filling cooling
system jackets with the antifreeze.
Install hose pinchers at the following
location:
XP DI Models
1. Water inlet hose
2. Engine cylinder drain hose
(coming from underneath engine)
1. Water outlet hose underneath tuned pipe
F15E03Y
1
F08E0GY
2
1
F08E0PY
1
smo2004-002a.book Page 98 Thursday, August 21, 2003 2:54 PM
www.SeaDooManuals.net