Specifications

83
MAINTENANCE
Lubrication
Use SEA-DOO synthetic grease or
equivalent and lubricate PTO flywheel.
Proceed as follows:
Remove seat to expose engine com-
partment.
Remove vent tube support (if so
equipped).
PTO Flywheel
Remove the fasteners and pull out PTO
flywheel guard.
TYPICAL — ALL MODELS
1. Flywheel guard
2. Wing nuts
Using a grease gun, carefully lubricate
PTO flywheel at grease fitting until
PTO flywheel boot begins to expand.
CAUTION: Immediately stop lubri-
cating as soon as PTO flywheel boot
begins to expand to prevent damage
or slipping.
1. PTO flywheel
2. Grease fitting
3. PTO flywheel boot
Reinstall and secure PTO flywheel guard.
XP DI Models
Seal Carrier
Using a grease gun, carefully lubricate
seal carrier of mid bearing until grease
is just coming out of seal.

WARNING
Only perform procedures as de-
tailed in this guide. It is recom-
mended that the assistance of an
authorized SEA-DOO dealer be
periodically obtained on other
components/systems not covered
in this guide. Unless otherwise
specified, engine must not be run-
ning and the safety lanyard must
be removed from its post for all
maintenance procedures. Compo-
nents inside engine compartment
may be hot. Never use jet pump
components or side vanes to lift
the watercraft.
F06I04Y
2
1
F01I0BZ
2
1
3
smo2004-002a.book Page 83 Thursday, August 21, 2003 2:54 PM
www.SeaDooManuals.net