Technical data

Section 04 ELECTRICAL SYSTEM
Subsection 02 (STARTER)
04-02-3
To remove bearing and seal in end cover, release
tabs of retainer.
1. Retainer
INSPECTION
For parts inspection, refer to the
1997 Sea-Doo
Shop Manual
, ELECTRICAL SYSTEM 07-04.
ASSEMBLY
Reverse the order of disassembly to reassemble
starter. However, pay particular attention to the
following.
Install new O-rings and gaskets.
Insert thrust washer onto armature shaft with the
non-metallic surface facing the end cover.
1. Non-metallic surface on this side
Install the 3 washers onto armature shaft, with
the thicker one in the middle.
1. Thick washer in the middle
When installing end covers to yoke, align index
marks.
Apply Loctite 271 (red) on through bolts and
torque to 6 N•m (53 lbf•
in
).
Apply Loctite 242 (blue) on Allen screws of starter
bracket and torque to 10 N•m (89 lbf•
in
).
F06H1MA
1
F06H1HA
1
F06H1NA
1
www.SeaDooManuals.net